Fulltext results:
- Repairing corrupted database
- u get an 'unexpected chunk number error for toast value..' in the messages.msgdata table then this means ... links between the main table data and the 'toast' values, or within the 'toast' value itself has been damaged. A similar problem is an "Invalid page header in ... s then INSERT INTO badids (msgdataid) VALUES(badid); raise notice 'data for messa
- Restore Deleted Calendars
- , filename, content, recurrence, objecttype, uid) VALUES(%s, %s, %s, %s, %s, %s, %s, %s, %s, %s)", (n... lendars (ownerid, name, lastupdate, internalname) VALUES(%s, %s, %s, %s) RETURNING calid", (newUserId, na
- v3/4 - Move the message store to a new folder/drive
- re\PaulSmith\VPOP3** and set the **MessageStore** value to point to the new location =====Restart VPOP3=
- How to install PostgreSQL to use another port
- P3\Database - Add/edit the PostGreSQLPort DWORD value to the new port number =====Create the VPOP3 use... s' (or use a different -U <username> and password value if you created a different superuser when setting
- Exceptions
- nistrator there is a 'Stack Dump' and some of the values in the Stack Dump will start with '673', eg '673
- How to move messages between users
- ce and target users and note their **usernumber** values (they will be called //<sourceuser>// and //<tar
- The ISP needs SMTP Authentication
- MTP Username'' and ''SMTP Password'' boxes (these values are given to you by your ISP) The ''Authenticat
- Error message: Your connection has been blocked temporarily - Try again later
- core reaches the ''Client Error Block Threshold'' value within the specified ''Client Error Monitor Perio
- Alternative method of automatically starting VPOP3
- ase the delay before VPOP3 starts, then alter the value after the '-n' line on the PING command in the ba
- Out of Disk Space When Sending Mail
- ulSmith\VPOP3\Secret * Create or edit a DWORD value called CheckDiskSpace and set it to 0 (zero)
- How to Obtain Error Logs
- the maximum size of these files to an appropriate value (10MB is good for a busy VPOP3 installation) on t... size of the main VPOP3 log file to an appropriate value (10MB is good for a busy VPOP3 installation) usin
- 450 4.3.2 Content Filter Timeout
- ing** and check the ''Maximum Incoming Sessions'' value. Normally this should be about 20-30 * in VPOP3... lts** section. Especially check the response time value (especially the ''max success time'' value). If these are showing an error or are over a few hundred mil
- Timeout while VPOP3DB is starting
- left side of the window - Find the 'ImagePath' value on the right side of the window. - Edit the ImagePath value. If the end of the setting contains something like '-t 300', increase the 300 value (this is the time to wait in seconds, so maybe in
- VPOP3 cannot access PostgreSQL - timeout expired
- (the password is 'pgsqlpass') If the displayed value is over about 100,000, then this may be the probl
- VPOP3 Status Service Disabled
- ber8** on the left. Then, on the right, check the value of the **Enabled** setting. If this is set to **0... opping the service), then, in RegEdit, change the value of the **Enabled** setting to **1** and [[start V