Fulltext results:
- Move VPOP3 Version 5 (or later) to a new PC
- the command prompt, enter ''pgsqlpass'' In this case, you will need to create the VPOP3 database again
- Repairing corrupted database
- to resolve the problem should be followed in that case as well. The only solution we know of is to dele
- Restore a database backup
- have arrived since the last good backup. In that case, run pgsql\bin\psql -U postgres -p 5433 (de
- Error 1348 - The validation information class requested was invalid
- for storing backups or archived messages. In the case where it was reported, it turned out that a Windo
- Error Messages
- r, and are just being reported by VPOP3 - in that case you should contact your Internet provider for hel
- How to Install VPOP3
- s a UPS with automated shutdown software. In this case, a power cut or glitch will cause the PC to reboo... s a UPS with automated shutdown software. In this case you will normally be OK with a power cut, but if ... to a corrupted database. This is especially the case if you have a 'continuous backup program', which
- Upgrading VPOP3 to version 8.x from v7 or earlier
- upgrade process, but it will protect your data in case something goes wrong, so we strongly recommend it
- How to upgrade VPOP3 to version 7 or later from version 6 or earlier
- upgrade process, but it will protect your data in case something goes wrong, so we strongly recommend it
- How To Move VPOP3 Version 2 to a New PC
- mith** instead). Note that registry key names are case insensitive, so your PC may have this as ''HKEY_L... 2Node\PaulSmith\VPOP3'' - Make sure the ''Match case'' box is unchecked - Press ''Replace All'' ===... g to) at step (3a) in the sequence above. In this case, you should also check for any possible issues wi
- How To Upgrade VPOP3 to version 5 or later
- VPOP3|back up your current installation]] just in case something goes wrong. Then simply run the install
- 550 5.7.1 Relaying not allowed! Bad sender IP address
- ex network with multiple subnets defined. In this case, you need to go to Services -> SMTP Server -> IP
- -ERR Can't open the message file - it's gone!
- with the ISP's technical support because it is a case of non-compliance with the standards. Further, i
- Error Message Handling
- (unless it gets a successful connection, in which case it will start again) Note that VPOP3 only reads
- Socket Error 10061 - The attempt to connect was forcefully rejected
- en unable to connect to the VPOP3 server. In this case you need to [[How To Check Whether VPOP3 Is Runni
- VPOP3 Deleting messages as 'old' messages
- w days even after the message has disappeared (in case it comes back again, to prevent duplicate downloa